To Next PageTo Next PageWhy my Viking VDB325 Dishwasher does not start?
If your Viking Dishwasher isn't starting, here are a few things to check: * Make sure the door is completely closed and that the door switch is working. * If the Delay Start option is on, turn it off. * Confirm that the water supply is connected and the water valve is open. * Ensure the power cord is properly connected to a power source. * Check the breaker to see if a fuse has blown.
What to do if my Viking VDB325 Dishwasher will not drain?
If your Viking dishwasher isn't draining, check the following: * Make sure the drain hose isn't obstructed or kinked. * Check the drain pump for any obstructions.
How to make Viking VDB325 dry dishes better?
If your dishes aren't drying properly in your Viking dishwasher, check these potential causes: * Make sure there's rinse aid in the dispenser. * Ensure dishes are loaded properly to allow for adequate water circulation. * Verify that the water temperature is hot enough for effective drying. * Check that the heater is functioning correctly.
How to prevent spotting and filming on dishes in my Viking VDB325 Dishwasher?
To address spotting and filming on dishes, consider the following: * Check the water hardness. * Inspect filters for any obstructions. * Add rinse aid and check the dispenser. * Check the amount of detergent you're using and make sure it's not old or caked.
Why Viking VDB325 Dishwasher will not fill with water?
If your Viking dishwasher isn't filling with water, consider these potential causes: * Ensure the door is fully closed and the door switch is functioning correctly. Remember to press START and shut the door within four seconds. * Check the water valve for any obstructions. * Verify the water supply and check the supply line for any issues.
Why are there small particles on dishes after washing in my Viking VDB325?
If you're finding small particles on your dishes after a wash cycle, here's what to check: * Use fresh detergent. * Make sure the wash arm can turn freely without being blocked by dishes. * Verify that the filters are free of obstructions.
Why is detergent left in the compartment of my Viking VDB325?
If detergent is being left in the dispenser compartment of your Viking dishwasher, consider these possibilities: * Make sure nothing is blocking the compartment. * The detergent may be old; try using new detergent. * Check that the dispenser is opening properly during the wash cycle.
How to fix Viking Dishwasher wash arms not rotating freely?
If the wash arms in your Viking dishwasher aren't rotating freely, it could be due to: * An obstruction blocking the arm's movement. Remove any items that may be in the way. * Low water pressure. Check the water pressure to ensure it's sufficient.
Why is there excessive foam in my Viking Dishwasher?
If you notice excessive foam in your Viking dishwasher, it's likely due to using the wrong type of detergent. Make sure you're only using dishwasher detergent.
What causes a blocked strainer in Viking Dishwasher?
A blocked strainer in your Viking dishwasher is caused by an obstruction. Remove the obstruction to resolve the issue.
General| Type | Built-In |
|---|---|
| Number of Racks | 2 |
| Wash Cycles | 6 |
| Capacity | 14 place settings |
| Energy Star Certified | Yes |
| Number of Programs | 6 |
| Noise Level | 45 dB |
| Control Type | Electronic |
Covers general and specific information for Viking Built-In Dishwasher models VDB325 and VDB450.
Provides crucial safety messages and alerts to prevent potential risks of fire, electric shock, and injury.
Provides warnings on water supply connections, electrical safety, and proper grounding for safe dishwasher operation.
Highlights electrical shock, excessive weight, and tip-over hazards, with essential safety precautions.
Provides step-by-step instructions to activate the diagnostic test mode for the Viking VDB325 dishwasher.
Provides step-by-step instructions to activate the diagnostic test mode for the Viking VDB450 dishwasher.
Lists common error codes, their probable causes, and recommended actions for troubleshooting dishwasher issues.
Continues the list of fail codes, causes, and troubleshooting actions for various dishwasher components.
Further details fail codes for dispenser, inlet valve, vent, blower, and heater errors, including AC power loss.
Details test points on the control board for diagnosing components, with typical resistance and voltage readings.
Explains diagnosing the door switch and detergent dispenser via control board connectors and voltage checks.
Details diagnosing the door vent (450 model) and circulation motor, including voltage checks and connector locations.
Covers diagnosing the fill valve and drain motor, including voltage, resistance, and disassembly.
Explains diagnosing the wash diverter and moisture sensor via resistance checks and component locations.
Details diagnosing pressure sensor, water heater, and user interface, including voltage and resistance checks.
Covers diagnosing the dryer motor and dryer heater (450 model) via voltage checks and connector locations.
Details removing the main control board, emphasizing caution for electronic circuits and static discharge.
Lists common problems, probable causes, and suggested corrections for dishwasher diagnosis and repair.
