8
G
Battery Charging & Recharging
WARNING:
If the battery is damaged in any way do not attempt to recharge
it. Contact Vileda service address (see last page).
Charge the battery for 12 hours before first use. After the first use, charging time is about 4-5 hours.
1. Connect the supplied battery charger into the battery charging socket located beside the power switch.
2. Once the battery is fully charged (the indicator will turn off) unplug the charger from the battery charging socket.
Battery autonomy is up to 80 minutes and decreases over time. All light indicators will flash red when battery level
is down. Then recharging is needed.
Using the Product
Before using, pick up objects like clothing, loose papers, pull cords for blinds or curtains, power cords, and any
fragile objects as they may entangle with the cleaning brushes. If the device passes over a power cord and drags
it, there is a chance an object could tumble off a table or shelf.
1. Ensure the battery is charged.
2. Place Vileda Relax Cleaning Robot in the middle of the room.
3. To turn Vileda Relax Cleaning Robot ON press the main power switch.
4. To START Vileda Relax Cleaning Robot, press one of the program buttons to choose the desired cleaning mode
(see section “Cleaning Modes”).
5. To PAUSE Vileda Relax Cleaning Robot, press one of the program buttons.
6. To RESUME Vileda Relax Cleaning Robot, press one of the program buttons again.
7. To turn Vileda Relax Cleaning Robot OFF, press the main power switch.
IMPORTANT:
For the most efficient cleaning, keep your floors as clear as possible (e.g. temporarily remove wires, rugs, chairs,
small objects, …). With less obstacles, Vileda Relax Cleaning Robot will move faster and clean more efficiently.
Cleaning Modes
Vileda Relax Cleaning Robot uses its robotic intelligence to navigate autonomously around the room.
It efficiently cleans the whole floor, also under furniture.
To Next Page
Loading...
