Vingtor CTB-20 User Manual

115 pages

To Next Page

INSTALLATION & USER MANUAL

CTB-100V

Command Talk Back & Public Address System

A100K10864

Table of Contents2
Purpose of this Manual3
Related Documents3
Publication Log3
Requirements3
General4
System Overview5
Introduction5
Features5
Optional Equipment6
Functions & User Facilities7
General7
Line Selection / Single Call7
Signal and Extra Signal Device for Substations7
Group Call7
All Call8
Calls from and between Operation Panels8
Call from Substations8
Parallel Communication9
AUX Function9
Audio from External Audio to All9
Operation of External Public Address System10
Emergency Public Address Operation10
Hands Free Operation11
Privacy Functions Ubstation STB-111
Two-Way Voice Communication, Nautical Safety11
Monitor Loudspeaker12
External Loudspeaker12
Dimmer of Call Light12
Volume Adjustment12
Powersupply SPS-4 (Option)12
Installation and Configuration Procedures13
General13
Mounting & Terminal Configuration13
Central Unit CU-100 & CU-20013
Operation Panel CTB-10 & 2015
Ctb-10W / V01, Ctb-20W / V0115
Identification Sign Plate CTB-Panels15
Substations and Other Equipment15
Identification Sign Plate Substation15
Cable Requirements15
Power Supply Requirements16
Set Priority in CU-100 & CU-20016
Set Receive-Call from Substation16
Set Public Address Zones SPA16
Volume and Signal Adjustment17
Substations17
Auxiliary and Public Address17
Call Signal17
Dimmer on / off in Operation Panel18
Substation STB-118
Substation STB-318
Substation STB-518
Installation for C500 Nautical Safety18
User Instructions19
Operation from the Operation Panel19
Make a Call to an Substation21
Make a Call to Group of Substations22
All Call23
Handsfree Operation24
Give Signal to Substations with Extra Signal Device24
Receive a Call from an Substation25
Receive a Call from Two or more Substations26
AUX Function27
Audio from External Audio to All28
Public Address Operation of External System29
Emergency Public Address Operation30
Volume32
Dimming of Call Light32
Parallel Communication33
Operation34
Operation from Substations35
- Operation from STB-138
- Operation from STB-238
- Operation from STB-339
- Operation from STB-540
- Operation from HE-112M / HE-112MT41
- Operation from STB-5GN41
- Operation from VH-10M / VH-10M-T42
- Operation from VHM-10 / VHM-10-T42
- Operation from NEBB-42EX / EX Loudspeaker43
- C500 Nautical Safety44
- Cable Inspection44
- Check Configurations44
- Commissioning44
- Mechanical Inspection44
- Starting up the System45
- Trouble Shooting46
- Volume Control46
- Datasheets49
- Installation Drawings49
- Installation Drawings and Datasheet49

Questions and Answers:

J
Jillian KnightAug 6, 2025
What to do if the Vingtor Speakers system is shut down and there is no light indication in CTB-panels?
- E
  elizabeth10Aug 6, 2025
  If the Vingtor Speakers system is shut down with no light indication in CTB-panels, here's what you should do: * First, check if there is voltage measured on terminal block X7 no.1-2 in the CU-unit. If there is no voltage, examine the 24V DC mains power supply or the SPS-4 power supply. * If the voltage is correct (24 – 32VDC) on terminal block X7 no.1-2 in the CU-unit, check the fuse marked F3 1AT.