1. GENERAL
1.1 Purpose of this manual
This manual supplies an engineer with the information required to install and commissioning
a CTB-100V system and the end-user with all necessary instructions for operating the CTB_100V system.
Refer to Service Manual for maintenance and repair.
The manual can also be used as a guideline for design and planning of the system.
1.2. Related documents
The following related documents are available:
Single line and connections drawing in Autocad format.
Declaration of conformity doc.no.DC CTB 20040601 SH
1.3. Publication log
Product / Ver.no.: CTB Ver.07
Title: CTB-100V Installation & User Manual
Doc.no. / Rev. CTB-100V_iu
Author: S.E.Nilsen
Verified By:
Revision Issued Changes / Comments
00 2001.09.06 First issue, User & Technical Manual
Draft I 2005.10.06 Second release, name changed to Installation & user
manual, CTB Ver.07 for approval
01 2006.06.08 Third release to meet requirement from Det Norske Veritas
(DNV)
01.1 2007.01.22 Replaced drawing CTB_cc3 Rev.04 with Rev.05
And dwg.CTB-100_cc2 Rev.04 with Rev.05
A100K10864 2008.08.26 New front and back page. Doc.no. CTB-100_iu Rev. 01.1
is replaced by this document no.
Zenitel Norway AS and its subsidiaries assume no responsibilities for any errors that may appear in this
publication, or for damages arising from the information in it. No information in this publication should be
regarded as a warranty made by Zenitel Norway AS.
The information in this publication may be updated or changed without notice. Product names mentioned in
this publication may be trademarks, they are used only for identification.
Zenitel Norway AS, August 2010
1.4. Requirements
The CTB system and its components have been tested according to following regulations:
• IEC 60533: Second edition, 1999; «Electrical and electronic installation in ships – Electromagnetic
compatibility».
• IEC 60945: Fourth edition, 2002; «Maritime navigation and radio communication equipment and
systems - General requirements - Methods of testing and required test results».
• IACS E10: Corr. 1 July 2003; «Unified environmental test specification – Testing procedure for electric
control and monitoring , safety and protection, on board computer based systems and peripherals,
loading instruments, internal communication and other electrical equipment as considered appropriate».
To Next Page
Loading...