EasyManua.ls Logo

Vingtor CTB-10 - User Manual

Default Icon
115 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
INSTALLATION & USER MANUAL
CTB-100V
Command Talk Back & Public Address System
A100K10864

Table of Contents

Questions and Answers

  • K
    Kimberly WardAug 6, 2025
    What to do if the Vingtor CTB-10 Speakers system is shut down and there is no light indication in CTB-panels?
    • M
      Mike MurphyAug 6, 2025
      If the Vingtor Speakers system is shut down with no light indication in CTB-panels, here's what you should do: * First, check if there is voltage measured on terminal block X7 no.1-2 in the CU-unit. If there is no voltage, examine the 24V DC mains power supply or the SPS-4 power supply. * If the voltage is correct (24 – 32VDC) on terminal block X7 no.1-2 in the CU-unit, check the fuse marked F3 1AT.
  • V
    veronicathomasAug 21, 2025
    What to do if Vingtor CTB-10 SPS-4 power supply fails?
    • J
      joshua70Aug 21, 2025
      If the Vingtor Speakers SPS-4 power supply fails, consider these steps: 1. Check the main power supply if there is no light in “DC ok” and there is an indication from failure contact X2 No.5-6(NO)or X2 No.6-7 (NC), considering that 230V AC or 115V AC may have failed and switched to 24V DC Emergency, or the power supply module may have failed. 2. Check the 5.0AT fuse at the terminal marked 3 2.1. If it still doesn't work, the power module may need repair or replacement.

Summary

3. INSTALLATION AND CONFIGURATION PROCEDURES

3.1 General

General guidance for system installation and configuration.

3.2 Mounting & Terminal configuration.

Instructions for mounting central units and configuring terminals.

3.4 Power supply requirements

3.5 Set priority in CU-100 & CU-200

Instructions for setting operational priority using DIP-switches.

4. USER INSTRUCTIONS

4.1 Operation from the operation panel.

Step-by-step guide for operating the system from the main panel.

4.3 Operation from substations.

5. COMMISSIONING

5.4 Check Configurations.

5.6 Starting up the system.

Steps for powering up and testing system components.

5.8 Trouble shooting.

Guide to diagnosing and resolving common system faults.

Vingtor CTB-10 Specifications

General IconGeneral
Weight1.5 kg
Rated power10 W
CategorySpeakers
MaterialAluminum
Impedance8 Ohm

Related product manuals