Feature Details
39
© 2009 Directed Electronics. All rights reserved.
Remote Start Error
For user safety, the system must be properly configured or remote start
will not activate. Refer to the table below for the screens and parking
light flashes that will identify the configuration issue and resolution.
Flashes * Possible Fault Solution
5 Brake on Release foot brake
6 Hood open Close hood
7 After performing Remote Start
command - MTS not enabled
After performing Timer Start or
Smart Start command
Enable MTS mode
Check all Solutions
8 Toggle Switch off Turn switch on
None Alarm is triggered Disarm or reset alarm
* Refers to the number of parking light flashes.
To Next Page
Loading...
