Viper AS1050R User Manual (English)

Other manuals for Viper AS1050R

Instructions For Use28 pages

Use And Maintenance2 pages

Questions and Answers:

C
cmitchellAug 5, 2025
Why is the recovery water vacuuming insufficient in my Viper AS1050R?
- R
  Ryan LewisAug 5, 2025
  Insufficient recovery water vacuuming in your Viper Scrubber can occur due to several reasons: - The recovery water tank might be full, requiring you to empty it. - The vacuum hose might be clogged, requiring cleaning. - The hose could be disconnected from the squeegee, so ensure it's properly connected. - The debris collection box could be full, or the squeegee hose outlet might be clogged, requiring you to clean them. - The squeegee could be dirty, or its blades might be worn or damaged, so clean and inspect it. - The tank lid might not be properly closed, the gasket could be damaged, or the standpipe tube could be clogged. Ensure the lid is closed correctly, replace the gasket if damaged, and clean the bend tube.
K
Kellie TaylorAug 10, 2025
How to resolve squeegee marks on the floor with my Viper AS1050R?
- J
  Jacob MckinneyAug 10, 2025
  If the squeegee on your Viper Scrubber is leaving marks on the floor, try these solutions: - Remove any debris under the squeegee blades. - Replace the squeegee blades if they are worn, chipped, or torn. - Adjust the squeegee using the adjustment knob. - Ensure the side splashguards are properly adjusted.
C
Christopher TownsendAug 16, 2025
What to do if my Viper AS1050R machine does not move?
- N
  Natalie MasonAug 16, 2025
  If your Viper Scrubber isn't moving, check these potential causes: - Ensure the ignition key is turned on. - Verify the emergency button is not pressed; release it if it is. - Make sure the operator is seated properly on the seat.
T
Terry LambAug 23, 2025
Why motors do not work and error code is on display of my Viper Scrubber?
- A
  Amber BrownAug 23, 2025
  If the motors aren't working and there's an error code on the display of your Viper Scrubber, consider these possibilities: - The battery connector might be disconnected; ensure it is properly connected. - The batteries could be completely discharged; charge them fully. - Restart the machine.
R
Ryan WilliamsAug 28, 2025
What to do if the solution flow to the brushes is insufficient in my Viper AS1050R?
- E
  Erica PerryAug 28, 2025
  If the solution flow to the brushes is insufficient in your Viper Scrubber, check these items: - The solution/clean water filter might be dirty; clean the filter. - The pump or valve might be broken; replace the broken one.