How to fix squeegee marks on the floor from Viper AS6690T?
If the squeegee on your Viper Scrubber leaves marks on the floor, it could be due to debris under the squeegee blades, or the blades may be worn, chipped, or torn. Remove any debris and replace the blades if necessary. Also, make sure that the squeegee has been adjusted with the knob; if not, adjust it.
Why is the recovery water vacuuming insufficient in my Viper AS6690T?
If the recovery water vacuuming is insufficient in your Viper Scrubber, several factors could be at play. The recovery water tank might be full, requiring you to empty it. Alternatively, the hose could be disconnected from the squeegee, so ensure it's properly connected. Check for clogs in the vacuum grid or a stuck float, cleaning as necessary. Inspect the squeegee for dirt or damage to the blades, cleaning or replacing them as needed. Confirm that the tank cover is correctly closed and the gasket is intact; also, check the standpipe tube for clogs. Finally, verify that the vacuum hose isn't clogged and clean it if it is.
What to do if the motors do not work and there is an error code on the display of my Viper AS6690T Scrubber?
If your Viper Scrubber's motors aren't working and an error code is displayed, it could be due to a few reasons. First, check if the battery connector is disconnected and connect it if it is. Second, the batteries might be completely discharged, requiring you to charge them. Finally, try restarting the machine.
What to do if my Viper Scrubber does not move?
If your Viper Scrubber doesn't move, it might be because the machine was turned on using the ignition key while keeping one of the switches pressed. To resolve this, turn the ignition key to “0” and then try starting the machine again without pressing any switches.
What to do if the solution flow to the brushes is insufficient in Viper AS6690T Scrubber?
If the solution flow to the brushes is insufficient in your Viper Scrubber, the solution/clean water filter might be dirty. Try cleaning the filter.
General| Model | AS6690T |
|---|---|
| Category | Scrubber |
| Power Source | Battery |
| Solution tank | 90 L |
| Brush speed | 180 rpm |
| Voltage | 24 V |
| Battery capacity | 240 Ah |
| Water Tank Capacity | 90 L |
| Run Time | 4 hours |
| Scrubbing width | 66 cm |
| Weight | 250 kg |
| Charging Time | 10 hours |
To Next Page
