4
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
US
ER!MANUAL!
So
lution tank filling
NOTE
The
machine can be filled with a hose or bucket. Do not remove the Solution filter (21) while filling.
1. Fi
ll water into solution tank (3) from the inlet (20) through hose or bucket.
2. Do not overfill the solution tank. It is best to leave a an inch from the top edge.
3. The water temperature must not exceed 40℃.
CA
UTION！
Use
only low-foam and non-flammable detergents, intended for automatic scrubber applications.
So
lution tank draining
NOTE
So
lution tank should be drained and cleaned after each scrubber operation is
completed.
1． Unscrew the drain cap (22) on the bottom of solution tank. The solution/water will flow freely
into a bucket or floor drain.
2． Rinse the solution tank with clean water after every use. This will help prevent chemical
buildup and clogging of the solution lid.
3． Replace the drain cap. (22)
Re
covery tank draining
NOTE
Re
covery tank should be drained and cleaned after each scrubber operation is
completed.
1． Turn the latch (17) on the recovery tank. Remove the recovery tank from machine by
grasping two grooves of tank and pulling up. Open the lid (1) and overturn the recovery tank
to drain the dirty water into a container, or unscrew the drain cap (22) to let water drain into a
bucket.
2． Clean and Rinse the recovery tank with clean water after every use.
3． Re-place the recovery tank on the machine and turn the latch (17) to lock the tank in place.
MA
CHINE OPERATION
1． Se
t the handle to a comfortable height by pressing level. (25)
2． Lower the squeegee (33) onto floor by pulling down the lift handle. (26)
3． Turn on the main power switch. (47)
4． Turn on the brush motor switch (48) and the solution switch. (50)
5． Turn on the vacuum motor switch. (49)
6． If necessary, adjust the water flow by manually turning the ball valve. (31)
7． Pull one or both operating triggers. (24) The brush will spin & solution will begin to flow. Push
the machine forward to start cleaning.
N
OTE
If
the battery indicator light (51) is green, the machine can be used. If it is yellow or red,
the batteries must be charged.
.
To Next Page
Loading...
