To Next PageTo Next PageWhy does the water from my Viqua VH410 appear milky?
If the water from your Viqua Water Filtration System appears milky, it's likely caused by air in the water lines. Run the water until the air is purged.
General| Model | VH410 |
|---|---|
| Type | UV Water Disinfection System |
| Application | Whole Home |
| Power Consumption | 60W |
| Lamp Life | 9000 hours |
| Inlet/Outlet Size | 1" MNPT |
| Maximum Operating Pressure | 125 psi (8.6 bar) |
| Operating Temperature | 2-40°C (36-104°F) |
| UV Dose | 40 mJ/cm² |
| Certifications | CE |
| Flow Rate | 18 GPM (68 LPM) |
Identifies various symbols and potential risks associated with the equipment.
Lists essential safety rules and warnings for operating the UV system.
Guide to mounting the UV disinfection chamber horizontally or vertically.
Steps for installing the UV system, including by-pass assembly and GFCI requirements.
Step-by-step guide for replacing the UV lamp after its lifespan.
Instructions for cleaning or replacing the quartz sleeve for optimal UV transmission.
Interpreting UV intensity readings and low UV level warnings.
Explains common error codes and display messages and their solutions.
