TIPS FOR USE WITH VISCOUNT MIDI PEDAL BOARDS
For correct use of Viscount MIDI pedalboards with Cantorum Trio – Duo Plus, we recommend setting the
parameters of the SHOES / PEDALBOARD function as shown in the following table:
Also be careful to the following:
- The Viscount 27N MIDI, 30N MIDI and 32N MIDI pedalboards are those for specific use with classic organs.
- The Viscount 18 and 25 pedalboards are those normally used with Legend organ series.
- Using a Viscount 27N MIDI, 30N MIDI or 32N MIDI pedalboard, the parameter values shown in the table are
to be used with the default pedalboard settings.
- Using a Viscount 27N MIDI, 30N MIDI or 32N MIDI pedalboard, the cables with jack connector coming from
the expression pedals of the pedalboard must be connected to the pedalboard’s [EXPR. 1] and [EXPR .2]
connectors and not to the [CRESC.] and [EXPR.] connectors of the Cantorum Trio – Duo Plus.
Furthermore, usually in [EXPR. 1] the left pedal must be connected, in [EXPR. 2] the right. In case of reversed
connection, also reverse the settings of the CRESCENDO and EXPRESSION parameters of the SHOES /
PEDALBOARD function.
- Using a Viscount 27N MIDI, 30N MIDI or 32N MIDI pedalboard, press [EXIT] in the calibration screen
displayed after setting the parameters of the SHOES / PEDALBOARD function, as it is not necessary.
- Using a Viscount 18N or 25N pedalboard, the cable with EXPRESSION jack connector coming from the
pedalboard’s expression pedal must be connected to the Cantorum Trio – Duo Plus [CRESC.] connector for
Crescendo control or [EXPR.] for expression control. It is also possible to connect the ROTARY cable to the
[SUSTAIN] connector of the Cantorum Trio – Duo Plus to control the Sustain effect of the orchestral voices.
To Next Page
Loading...
