Table of Contents
VT200/220 Technical Manual, Rev 1.00.01 v Doc # TM-VT200/220-EN
Full Protocol Workflow....................................................................................................55
Relevant Setup Parameters.............................................................................................55
EDP Data Block Composition...........................................................................................56
6.3.8 Remote Printer Output....................................................................... 56
6.3.9 Master-Slave Protocol Output ............................................................. 56
Master-Slave Commands................................................................................................56
Gross-Tare-Net Weight Transmission ............................................................................... 58
Tare Presetting via PC....................................................................................................59
Separation of COM1 and COM2 Network Addresses............................................................ 59
6.4 STANDARD PRINT FORMATS ..................................................................... 60
6.5 CUSTOM PRINT FORMATS ........................................................................ 61
6.5.1 Creating a Custom Print Format.......................................................... 61
6.5.2 Downloading a Custom Print Format.................................................... 62
7 OUTPUTS AND DIGITAL INPUT....................................................... 64
7.1 SPECIFICATIONS .................................................................................. 64
7.1.1 Digital Outputs................................................................................. 64
7.1.2 Analog Outputs ................................................................................ 64
7.1.3 Digital Input (Tilt Switch)................................................................... 64
7.2 CONNECTING DIGITAL OUTPUTS AND TILT SWITCH .......................................... 65
7.3 SETTING THRESHOLDS FOR DIGITAL SETPOINTS.............................................. 65
7.4 CONFIGURING ANALOG OUTPUT................................................................. 66
7.4.1 Connecting PCB and Setting Jumper.................................................... 67
7.4.2 Setting Analog Output Parameters ...................................................... 68
7.4.3 Calibrating D/A Converter .................................................................. 69
7.5 USING THE TILT SWITCH......................................................................... 70
7.5.1 Tilt Switch Options............................................................................ 70
8 SERVICE OPERATIONS AND TESTING............................................. 71
8.1 SERVICE OPERATIONS ............................................................................ 71
8.1.1 Setting and Changing Calibration Password (Function 40)....................... 71
8.1.2 Setting Date, Time and Serial Number (Function 05).............................. 71
8.1.3 Displaying Remaining Battery Capacity (Function 02)............................ 72
8.1.4 Checking Calibration Seal (Function 48).............................................. 72
To Next Page
Loading...
