VISICO Speedlite VS-765 - Troubleshooting Guide; Power and Firing Issues; Auto Zoom Malfunctions; Exposure Problems

If there is highly reflective object (glass window,
etc) in the picture , please use FE lock.
When use high-speed sync, the effective flash
range is shorter. Move closer to the subject.
In Manual mode, change flash output power.
In TTL mode, if the subject looks very dark or very
bright, please set flash exposure compensation.
Change camera shutter speed, aperture, and ISO.
Secure the flash's mounting foot on camera.
Thepictureisoverexposureor
underexposure
Thepicturehasdarkconnersoronlyapartof
thesubjectisilluminated.
Check the flash coverage you set. This flash unit
has the flash coverage between 24 to 105mm,
which fits medium-format cameras. Pull out the
wide panel to extend the flash coverage.
Autozoomdoesnotwork
When set as a MASTER flash, the power will
turn off automatically after approx. 90 seconds of
idle use. To wake up the Speedlite again, press
camera shutter halfway or press any flash button.

Thepowerturnsoffautomatically
When set as a slave flash, it will go to sleep mode
after approx. 60 minutes of idle use. To wake up
the Speedlite again, press any flash button.
·
·
·
·
·
·
·
·
·
·
Make sure the battery is installed in correct
polarity.
 Insert mounting foot into camera's hot shoe
all the way, and secure the flash on the
camera.
 If recycling time of flash is longer, please
replace the batteries.
 If the electrical contacts of the flash and
camera are dirty, clean the contacts.
·
·
·
22