Visonic KP-160 PG2 User Manual

Arming and Disarming the System
Step Basic Arming User Actions Keyboard & Panel Response
1 Select a PARTITION
(if Partition is enabled)
Any combination of
The selected key blinks.
2
Arm AWAY
(3) + [present TAG] or [Enter code]
The selected key and the Present
Prox Tag key (
) begin to blink and
prompt you to present your tag or enter
your code.
The Keypad’s LED blinks red once to
indicate transmission of the arming
command to the control panel. The LED
and the buzzer then indicate the control
panel’s response – see “System Status
and Indications” section 3.3.
Arm HOME
(2) + [present TAG] or [Enter code]
Disarm (OFF)
(1) + [present TAG] or [Enter code]
3 Quick arm AWAY (if Quick Arm
is enabled)
(3) (≈ 2 sec.)
Quick arm HOME (if Quick Arm
is enabled)
(2) (≈ 2 sec.)
4 INSTANT
(After arming HOME/ AWAY)
(4)
LATCHKEY
(After arming AWAY)
(5)
Initiating Alarms
Alarms Actions Response Notes
Emergency alarm
(0) (≈ 2 sec.)
See section 3.2. Shortly after pressing the Emergency or Fire icon, the KP-160
PG2 emits beeps until the KP-160 PG2 sends the command.
Fire alarm
(≈ 2 sec.)
See section 3.2.
Panic alarm
(0)
(≈ 2 sec.)
See section 3.2. Shortly after pressing the Panic icon, the KP-160 PG2 emits
beeps until the KP-160 PG2 sends the command.
Zone Status
State of Detector Actions Notes
For NOT READY (
) / BYPASSED ( )
(8) Upon each press of the (8) key, the next zone
number appears on the Zone # display,
.
Zone Status when working with Partitions
State of Detector Actions Notes
For NOT READY (
) / BYPASSED ( )
/ /
(8)
Upon each press of the (8)
key, the next zone
number assigned to the pressed Partition number
appears on the Zone # display,
.

Visonic KP-160 PG2 Specifications

General

Brand	Visonic
Model	KP-160 PG2
Category	Keypad
Language	English