Visonic PowerMaster 360 User Manual

ELECTRICAL APPLIANCE CONTROL
D-307503 PowerMaster 360 User's Guide 11
Arming AWAY or HOME ‘Instant’
Pressing during the exit delay arms the system immediately without a delay. Therefore, any detection in
any zone triggers an immediate alarm. To arm AWAY-INSTANT, proceed as follows.
PRESS
RESULTING DISPLAY
ENTER CODE _ _ _ _
Code
ARMING AWAY
ARMING INSTANT
(alternating)
PLEASE EXIT NOW
Vacate the premises
 (Exit delay) 
AWAY
ARM indicator lights during the armed state.
Forced arming AWAY or HOME
Forced arming allows you to arm the system even if the system is "NOT READY". Any open zones will be
bypassed for the duration of arming.
Note: When forced arming is carried out, the buzzer “protests” by emitting a continuous tone during the exit
delay until the last 10 seconds of the delay. You can silence this signal by pressing the arming button again.
If forced arming is enabled and you wish to arm the system when NOT READY is displayed, complete the
following steps:
PRESS
RESULTING DISPLAY
ENTER CODE _ _ _ _
[Enter code] /
[Present tag]
Code / Present tag
ARMING AWAY
PLEASE EXIT NOW
(to mute the buzzer)
Vacate the premises
 (Exit delay) 
AWAY
ARM indicator lights during the armed state.
Remember: Forced arming compromises security!!

Visonic PowerMaster 360 Specifications

General

Brand	Visonic
Model	PowerMaster 360
Category	Security System
Language	English