ELECTRICAL APPLIANCE CONTROL
12 D-307503 PowerMaster 360 User's Guide
Forced arming “HOME” is performed in a similar manner, as follows:
[Enter code] /
[Present tag]
(to mute the buzzer)
Go to interior zone
ARM indicator flashes during the armed state.
Arming in latchkey mode
This mode, if enabled by the installer, is useful for example when a parent wants to be sure that their children
have returned from school and have disarmed the system. A special “latchkey” message is sent out when the
system is disarmed by a “latchkey user”.
Latchkey users are holders of user codes or users of keyfob transmitters 5 through 8. The latchkey message is
considered an alert and not an alarm. The message is sent to private telephone numbers that are programmed
by the user to receive alert messages.
Latchkey arming is possible only when you arm “AWAY”. To arm using the Latchkey mode, proceed as follows:
Note: Latchkey must be enabled by your installer.
ARM indicator lights during the armed state.
Initiating alarms
The following are various methods that can be used for initiating alarms.
Initiating panic alarm
You can generate a panic alarm manually in the disarmed and armed states, as follows:
To stop the alarm, press the
button
and then key in your valid user code.
To Next Page
Loading...
Need help?
General
