Visonic PowerMaster 360 - Exiting the Event Log

MAINTENANCE
52 D-307503 PowerMaster 360 User's Guide
READY 00:00
1.
ENTER CODE:_
2.
CODE
When the Virtual Keypad display reads [ENTER CODE: _], enter the current
master user code.
LIST OF EVENTS
The "Success Tune" will sound and the Virtual Keypad display will read [LIST
OF EVENTS]. (see Important Note!)
3.
Click the button. The latest event will be shown.
Z13 alarm
The event is displayed in two parts, for example, "Z13 alarm" then "09/02/10
3:37 P".
The two displays will be shown alternately until clicking again to move
to the next event or until the event log times out (4 minutes).
09/02/10 3:37 P
4.
Click the button as many times as necessary to read all the required
data.
Important Note! Entering an incorrect code 3 times in a row, and each next
retry, will initiate a 30-second penalty lockout of the keypad.
Attention: The system will not allow you to erase the event log. Only the
installer is authorized to view and perform this function.
Exiting the event log
1.
or
Click the or button from anywhere within the event log.
The Virtual Keypad display will read [<OK> TO EXIT].
<OK> TO EXIT
2.
Click the button.
READY 00:00
The system reverts to the normal operating mode.