Visonic PowerMaster 360

MENUS AND FUNCTIONS
20 D-307503 PowerMaster 360 User's Guide

1. Zones will be bypassed throughout one disarm-arm period only. Disarming the system after arming will
suspend the entire bypassing scheme but you can recall and reuse it as described in section B.3.
2. Fire zones cannot be bypassed.
3. Carefully read the section titled "Additional Information" according to the indicated references
1
etc. –
see table at end of section B.3.
REMEMBER – ZONE BYPASSING COMPROMISES SECURITY!
A. To bypass a zone
1.
SET ZONE BYPASS
Enter the [USER SETTINGS] menu
1
, select the [SET ZONE BYPASS]
2
option and press .
Z01: READY
The first zone, Z01, is displayed.
3
Z01: P1 P2 P3
4
Living Room
2.
or
Click the or button until the display reads the zone you wish
to bypass (or clear bypass), for example, "Z04" for Zone 04. After several
seconds the LED on the respective device starts flashing indicating "it's me".
Z04: NOT READY
Z04: P1 P2 P3
4
3.
Kitchen
When the display reads the zone you wish to bypass press .
4.
<OK> TO BYPASS
The display now reads [<OK> TO BYPASS].
5
To bypass the selected zone press
5.
Z04: BYPASSED
A "Success Tune" ☺ sounds and the updated zone status is now displayed
i.e. [ Z04: BYPASSED ].
8
B. To Clear a Bypassed Zone
6.
Z04: BYPASSED
Repeat steps 1 to 2 above.
Z04: P1 P2 P3
4
7.
Kitchen
When the zone you wish to clear bypass appears on the display (for
example, "Z04"), press to confirm. You can also identify the device
by looking for the "it's me" LED indication on the displayed device.
<OFF> TO CLEAR
The display now reads [<OFF> TO CLEAR].
5
8.
To clear the bypassed zone, press the button.
Z04: READY
A "Success Tune" ☺ sounds and the updated zone status is now
displayed, i.e. [ Z04: READY ] or [ Z04: NOT READY ].
9