Visonic PowerMaster 360

TESTING THE SYSTEM
48 D-307503 PowerMaster 360 User's Guide
C. To display the temperature and
light intensity
7.
TEMP/LIGHT TEST
The display now reads [TEMP/LIGHT TEST].
8.
To display the temperature or light intensity of zones on the control panel,
press .
6
Z01 24.5C
The panel reads the temperature and light intensity of each zone. The display
alternates between the temperature, the light intensity, the sensor number
and the sensor location.
7
Repeatedly click the button to review the temperature and light
intensity of each zone.
Z01:LIGHT (**)
Z01:Temp. Sensor
Guest room
9.
DEVICE TESTS END
When the temperature of all zones has been reviewed, the display reads
[DEVICE TESTS END]. Press the or the button to confirm the
test and then move to the next step to test the other devices.
or
D. To test all other devices
TEST ALL DEVICES
The display now reads [TEST ALL DEVICES].
10.
To enter the devices test procedure, press .
11.
NOT ACTIVE NNN
The display reads [NOT ACTIVE NNN]. NNN indicates the number of enrolled
devices in the panel that have not been tested yet. This number automatically
drops one count for every tested device. To initiate devices test, press .
Z01 NOT ACTIVE NNN
The display shows the 1
st
device in the list of untested devices. The display
alternates between the device number, the device type (e.g. magnetic
contact, keyfob, keypad, etc.), and the device location.
The test is performed by activating each device as explained in point 8 in the
Additional Information table below.
Z01 CONTACT
FRONT DOOR
12.
Click to scroll through the list of all untested devices.
9
13.
DEVICE TESTS END
When all devices have been activated, the display reads [DEVICE TESTS
END] followed by [READY 00:00].
READY 00:00
or
Press the or the button to confirm the test and then move to
the next step to test the email.
E. To test Emails
14.
E-MAIL TEST
The display now reads [E-MAIL TEST].
10
15.
To enter the email test procedure, press .
Please wait…
16.
Pls chck MailBox
Check the private email inbox to view the sent email.
☺ Return to step 14