USER SETTINGS
DE5468U 25
used to temporarily remove from service faulty zones that
require repair work. Fire and temperature zones can not
be bypassed.
Remember – zone bypassing compromises security!
Note: Zones will be bypassed throughout one
disarm-arm period only. Disarming the system after
arming will suspend the entire bypassing scheme.
B. Bypassing Procedure
For PowerMax Pro with partition feature, you may set
the bypass option according to the type of partition
access permission.
Having entered your user code
successfully (see above
- Entering the User Settings Menu), the display will read:
SET BYPASS
If at this point you click , the number and
state of the first zone / partition containing the first
zone (in PowerMax Pro with partition feature) will be
automatically displayed. Three states are then made
possible:
• Open: The zone is not secured - you can
bypass the zone if you do not wish or know how
to solve the problem right away.
• Bypassed: The zone is presently bypassed
(you bypassed it before but have not armed the
system yet).
• Functional: If there is nothing wrong with the
zone, its state is described as "Functional
".
Let us assume that Zone 1 in partition 3 is "open"
and you wish to bypass it, and the rest of the zones
are functional.
PRESS
RESULTANT DISPLAY
Z01 OPEN
(alternating)
KITCHEN
<OK> TO BYPASS
Z01 BYPASSED
(alternating)
KITCHEN
Z02 FUNCTION
(alternating)
FRONT DOOR
(If you wish
to check the
state of the
next zone)
SET BYPASS
You can select any other item on the USER SETTINGS
menu or quit programming by clicking
. When <OK>
TO EXIT is displayed - click
button.
At the end of the bypassing operation, BYPASS
blinks:
READY BYPASS or NOT READY BYPASS
This indication will persist as long as the system
remains disarmed, and will disappear once the
system is armed.
Note: BYPASS will alternate in the display with other
messages, such as: TRBL, MEM and MSG.
C. "Unbypass" Procedure
Suppose you wish to restore zone 22 of partition 3
after having completed the bypassing scheme. Simply
re-enter the SET BYPASS menu (see Bypassing
Procedure above), and click
or until
the zone you wish to "unbypass” in the desired
zone/partition is displayed. Refer to the following steps.
PRESS
RESULTANT DISPLAY
Z22 BYPASSED
(alternating)
LIVING ROOM
<OFF> TO CLEAR
Z22 FUNCTION
(alternating)
LIVING ROOM
You may now click and then select any other
item on the USER SETTINGS menu, or click
to quit programming. When <OK> TO EXIT appears
- click
.
Reviewing the Bypassed Zone List
Having entered your user code successfully (see
above - Entering to the User Settings Menu), the display
will read:
PRESS
RESULTANT DISPLAY
SET BYPASS
Enter user code
SHOW BYPASS
BYPASS LIST
If at this point you click , the number, state
and name of the first bypassed zone will be displayed.
You can now click
repeatedly to review all
bypassed zones, in ascending numerical order. When
done, clicking
will get you back to SHOW
BYPASS and clicking
will get you back to
<OK> TO EXIT.
Recalling the Last Bypass Scheme
Arming the alarm system with several zones in the
bypassed state is in fact "partial arming". An
identical partial arming may be repeated by recalling
the last bypassing scheme (that was suspended and
memorized upon disarming the system).
To Next Page
Loading...
