USER SETTINGS
30 DE5468U
Notes: (1) Functions inside black rectangles are accessible only if master user code was entered.
(2) For the year, enter the two last digits only.
(3) Press
to display the number, state and name of first bypassed zone. Press repeatedly to view all the bypassed zones.
(4) To enter "A" (AM) press
(or one of the 3 keys above it), to enter "P" (PM) press (or one of the 3 keys above it).
(5) SET/SHOW/RECALL BYPASS menus are accessible only if "manual bypass has been selected by the installer.
(6) In the SET VOICE OPTION, if you select "enable prompts", the Control Panel mute speaker button
is active.
(7) This menu is not available when partition is enabled.
Moving forward
Moving backward
Moving one level
up in the menu
Return to
“<OK> TO EXIT”
To move within
most of
the menus, the following
keys can be used:
Show / confirm
data
DEFINE PWRLNK
device number (2-digit)
SCHEDULER
DEVICE No.
Black box is displayed
regarding 2-way X-10 unit
If you enter “00” and
press OK, PGM is displayed
(See figure 8)
SUNDAY MONDAY TUESDAY WEDNESDAY FRIDAY SATURDAY DAILY
start - HH:MM
stop - HH:MM
or
TIME - - / - -
(enter start/stop time)
Notes
1. Select time in 10 minute interval only.
2. To erase a displayed time, press OFF.
OPERATION No. 1 OPERATION No. 2 OPERATION No. 3 OPERATION No. 4
THURSDAY
Figure 8 DETAIL "A" - Scheduler Function
Deleting Proximity Tags
Proximity tag memory locations must be cleared
(enrolled ID must be deleted) before enrolling a new
ID. To delete an existing ID, proceed as follows:
A. Select the desired memory location, as described in
the previous paragraph, steps A-C. If, for example,
you selected Tag No. 5, the display will read:
Tag No. 5
B. Click . The display will change to:
<OFF> TO DELETE
C. Click . The display will change to:
Tag No. 5
Note that the dark box at the far right has
disappeared. It is now possible to enroll a new ID. It
is also possible to leave the cleared zone or memory
location free and simply exit to the main menu.
Setting the Voice Options
Remember: Voice prompts are heard over the built-
in loudspeaker subject to two conditions:
- The voice option is enabled as shown below
- The loudspeaker is enabled by pressing the “7”
key (see Chapter 3 - Voice ON-OFF)
Here you may select one of two options:
Enable prompts: Voice announcements
Disable prompts: No voice announcements
The presently programmed option will be shown, with
a dark selection box (
) at the far right of the display.
You may view the other option (that does not have a
dark box at the far right) by clicking
. A
dark box will appear if you click
while the
other option is displayed.
To set the voice option, proceed as follows:
Having entered your Master User Code
successfully
(see above - Entering the User Settings Menu), click
the
button until the display reads:
SET VOICE OPTIONS
From here, proceed as follows:
PRESS
RESULTANT DISPLAY
enable prompts
(if this is the current option)
disable prompts
If not satisfied
disable prompts
If satisfied -
To Next Page
Loading...
