15 HOMEDEPOT.COM
Please contact 1-855-847-7264 for further assistance.
CLEANING OR REPLACING GREASE FILTER
□ Remove screw from the plastic lter retainer clip with screwdriver.
□ Slide down the lter retainer to release lter.
□ Reinstall the lter. Placing the back edge in the channel at rear
of hood. Push lter into place, slide back the clip to secure lter
to range hood.
□ Replace screw in the lter retainer.
□ To clean grease lter. Soak the lters in hot water using a mild
detergent. Rinse well and shake to dry. Or place in upper rack of
dishwasher to clean.
NOTE: Do not use ammonia. The aluminum on the
grease lter will corrode and darken.
NOTE: You can use either dishwasher or hot detergent
solution and rinse in clean water.
NOTE: The grease lter is dishwasher safe. To avoid
grease lter damage while cleaning, place lter into the
dishwasher top rack for cleaning.
REPLACING THE INCANDESCENT LIGHTBULB
□ Turn off the range hood and allow the light bulb to cool.
□ Disconnect power, turn off house breaker at breaker box.
□ Remove screw from plastic lens cover.
□ Lift right side to remove cover.
□ Screw a 40 W max 120V incandescent light bulb into socket.
□ Replace lens cover and secure with screw.
□ Reconnect power. If new light does not operate, make sure the
lamp is inserted correctly before calling service.
CHARCOAL / GREASE FILTER
□ For recirculating vent hood, an optional charcoal lter is
available and already installed in lter.
□ The charcoal lter is not washable. It should last up to 6 months
with normal use. Replace the old charcoal lter with a new one.
□ If you want to transform your hood for outdoor exhaust system
you must remove the charcoal layer from the lter.
□ The charcoal layer is secured with a set of staples at the center
of the lter; to remove the layer without damaging the lter,
separate the edges of the charcoal from the frame until only the
staples are left holding it.
□ Pull the charcoal layer in the direction parallel to the staples.
If you pull in other direction, it could be more difcult to detatch
and the lter may suffer certain level of deformation.
□ The layer can easily be removed by hand but in case of need,
use scissors to cut it out.
Care and Cleaning (continued)
To Next Page
Loading...
