Vissani 30BLC19PRT User Manual

2
Table of Contents
Table of Contents ...................................2
Safety Information ..................................2
Warranty ..........................................4
Pre-Installation .....................................5
Package Contents ...................................6
Installation .......................................13
Care and Cleaning .................................15
Troubleshooting ...................................16
Wiring Diagram ....................................17
Service Parts ......................................18
Safety Information
READ AND SAVE THESE INSTRUCTIONS
WARNING: To reduce the risk of re, electric shock, or
injury to persons, observe the following.
□ Use this unit only in the manner intended by the manufacturer. If
you have any questions, contact the manufacturer.
□ Before servicing or cleaning unit, switch power off at service panel
and lock service disconnecting means to prevent power from being
switched on accidentally. When the service disconnecting means
cannot be locked, securely fasten a prominent warning device,
such as a tag, to the service panel.
□ Installation work and electrical wiring must be done by qualied
person(s) in accordance with all applicable codes and standards,
including re-rated construction.
□ Sufcient air is needed for proper combustion and exhausting
of gases through the ue (chimney) of fuel burning equipment
to prevent back drafting. Follow the heating equipment
manufacturer’s guidelines and safety standards such as those
published by the National Fire Protection Association (NFPA), and
the American Society for Heating, Refrigeration and Air Conditioning
Engineers (ASHRAE), and the local code authorities.
□ When cutting or drilling into a wall or ceiling, do not damage
electrical wiring and other hidden utilities.
□ If provided with an electrical plug, connect the hood to a
receptacle that complies with current regulations and placed in
an accessible position. Where an electrical plug is not provided
(direct connection to electrical network) or the plug will not be in
an accessible position after installation, place an approved bipolar
switch in accessible position that provides full disconnection under
overvoltage category III conditions, in accordance with local wiring
rules.
□ Ducted fans must always be vented to the outdoors.
WARNING: Fuel (gas) burning ranges must be vented outdoors
using, at minimum, metal ductwork and range hoods of sufcient
capacity.
□ Follow your fuel burning equipment manufacturer’s guidelines, as
well as all applicable safety standards published by the National
Fire Protection Association (NFPA), and the American Society for
Heating, Refrigeration and Air Conditioning Engineers (ASHRAE),
and your local code authorities.
DANGER: Turn off the power circuit breaker or the power switch
on the junction box before installing or servicing this unit. Touching
circuitry inside the range hood while it is energized will result in
death or serious injury.
DANGER: All electrical wiring must be properly installed,
insulated, and grounded. Improper insulation and grounding will
result in deadly electrical shock.
DANGER: If installing this unit over a gas range, turn off the gas
at the source before installing or servicing this unit.

Vissani 30BLC19PRT Specifications

General

Brand	Vissani
Model	30BLC19PRT
Category	Ventilation Hood
Language	English