Vitec Multimedia MGW Ace Decoder OG - System Page; Network Interface Configuration

MGW Ace Decoder OG
User Manual, Version 2.0 44
The System Page
In the System page you set the parameters of the following tabs:
 Network Interfaces
 Date and Time
 Security
Figure 6-7: The System page
To set the system parameters:
1. From the main menu, select System.
2. Set the desired parameters as required in each section and click Apply.
To set the Network Interfaces:
Two network interfaces are available. Each one can be used for either management and/or
streaming:
 Ethernet 1 : Ethernet Port is connected to the openGear chassis/frame port located at
the back of the chassis.
 Ethernet 2 : Rear I/O module Ethernet port