Customization
6
Vivint Element CT200 Operation Guide
Display
The Thermostat display can
operate in one of two modes:
Approach or Button Tap.
Approach means that the device’s
display will automatically turn
on when it senses you approach
within 4 (four) feet of the unit.
Button Tap means that you will
have to press one of the buttons
on the unit to wake the display.
1. From the Home screen, press
and hold the SIDE button for
three (3) seconds.
2. Press DOWN to highlight Display, then press the SIDE button. The
current Display On behavior has a check mark next to it.
3. Press UP or DOWN to select a behavior, then press the SIDE
button to conrm.
Info
Information about the Thermostat device includes:
POWER: The power supply the
unit is currently using
(batteries, C-wire, and/or
transformer).
BATTERY: How much battery
power is currently left, if
batteries are installed in
the unit.
HEATING: The heating setting the
system is currently using.
ACTIVE RELAYS: The wires
currently being used by
the system.
NETWORK: Whether or not the unit is currently connected to a
Z-Wave network.
SOFTWARE: The current software and rmware versions the unit is
using.
POWER
24VAC
BATTERY
85%
HEATING
HEAT PUMP
AUX. HEAT
ACTIVE RELAYS
Y, O, G
NETWORK
CONNECTED
SOFTWARE
D-V1.23
Z-V1.23
INFO
Approach
Button Tap
DISPLAY ON:
38
To Next Page
Loading...
