Vivint Element CT200 - Page 42

Customization
6
Vivint Element CT200 Operation Guide
5. Highlight Link, then press the SIDE button. The unit attempts to
connect to a local Z-Wave Network.
RESET
The Network>Reset resets the
Thermostat's radio to unlink it
from its linked Z-Wave Controller.
Use this option before replacing
your Z-Wave Controller so that
your Thermostat can connect to
the new controller.
1. From the Home screen, press
and hold the SIDE button for
three (3) seconds.
2. Press DOWN to highlight
Installer, then press the SIDE
button.
3. Press DOWN to highlight Network, then press the SIDE button.
4. Press DOWN to highlight Reset, then press the SIDE button.
5. To conrm that you want to reset the connection, press DOWN to
highlight Reset, then press the SIDE button.The connection resets.
Testing
Testing options enable you to test the functionality of your heating
and cooling equipment’s connection to the Thermostat. For
instructions on running these tests, see page 20 in the Installation
Guide.
Installer: Network/Reset Cont.
Reset
RESET
Are you sure?
42