Vivitek D330MX - Maintenance and Security; Replacing the Projection Lamp

DLP Projector—User’s Manual
– 36 –
M AINTENANCE AND S ECURITY
Replacing the Projection Lamp
The projection lamp should be replaced when it burns out. It should only be replaced with a certified
replacement part, which you can order from your local dealer.
Important:
a. The projection lamp used in this product contains a small amount of mercury
b. Do not dispose this product with general household waste.
c. Disposal of this product must be carried out in accordance with the regulations of your local
authority.
Warning:
Be sure to turn off and unplug the projector at least 30 minutes before replacing the lamp. Failure to
do so could result in a severe burn.
1.
Loosen the two captive
screws on the lamp
compartment cover (A).
2.
Remove the lamp com-
partment cover (B).