VivoLink VLHDMIMAT4X4 - 4 Panel Button Control; I;O Connection Switching; EDID Configuration

4K 4x4 HDMI2.0 Matrix Switcher
6
4. Panel Button Control
4.1 I/O connection switching
The front panel features four input selection buttons and four output selection buttons for
switching I/O connection.
1) To convert one input to an output:
Example: Input 1 to Output 3
→ Press INPUTS 1 + OUTPUTS 3
2) To convert an input to several outputs:
Example: Convert Input 2 to Output 3 and 4
→ Press INPUTS 2 + OUTPUTS 3 + OUTPUTS 4
NOTE: Indicators of the pressed buttons will blink green for three times if the conversion
is done, then it will be off. If the conversion failed, they will be off immediately.
4.2 EDID Configuration
The rear panel boasts a 4-pin EDID DIP switcher to manage EDID. The EDID data and
its corresponding DIP switcher status are shown in the below list.
DIP Switcher
NO.
Status
EDID
0 0000 Pass-through (default)
1
0001
720P 2D Pass-through CH
2 0010 720P 3D Pass-through CH
3
0011
1080P 2D Pass-through CH
4
0100
1080P 3D Pass-through CH
5 0101 4K@30HZ Pass-through CH
6
0110
4K@30HZ 2.0CH
7 0111 4K@30HZ 7.1CH
8
1000
4K@60HZ 4:2:0 Pass-through CH
9
1001
4K@60HZ 4:2:0 7.1CH
10 1010 4K@60HZ 4:4:4 Pass-through CH
11
1011
4K@60HZ 4:4:4 7.1CH
1111
Enable Software EDID management
mode: RS232 control or Web-based GUI
control