VivoLink VLHDMIMAT4X4 - 5 IR Control

4K 4x4 HDMI2.0 Matrix Switcher
8
5. IR Control
The Matrix Switcher features one built-in IR receiver to receive IR signal from IR remote
to enable IR control. If the external IR receiver or other IR control device need to be
used, the IR IN port on rear panel can be connected.
Here is a brief introduction to the IR remote:
① Standby button, press it to enter/ exit standby mode.
②
INPUTS:
Input channel selection buttons, same with the
corresponding front panel buttons
③
OUTPUTS:
Output channel selection buttons, same with the
corresponding front panel buttons
④
Menu buttons: ALL, EDID, CLEAR and ENTER.
 ALL: Select all inputs/outputs.
To convert an input to all outputs:
Example: Input 1 to all Outputs:
→ Press INPUTS 1 + ALL + ENTER
 EDID management button:
1) One input port learns the EDID data from one output
port.
Example: Input 2 learns EDID data from output 4:
→ Press EDID + INPUTS 2 + OUTPUTS 4+ ENTER
2) All input ports learn EDID data from one output port.
Example: All input ports learn EDID data from output 3:
→ Press EDID + ALL + OUTPUTS 3 + ENTER
 CLEAR: Withdraw button.
 ENTER: Confirm operation.