EasyManuals Logo

Vivotek PZ7112 User Manual

Vivotek PZ7112
126 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #45 background imageLoading...
Page #45 background image
VIVOTEK
User's Manual - 45
3�
WPA-PSK: Use WPA (Wi-Fi Protected Access) pre-shared key
More secure than WEP, the Wi-Fi Alliance developed WPA (Wi-Fi Protected Access) in 2003 to
address WEP’s weaknesses� Improvements included TKIP, which changes the encryption key for each
data transmission�
Algorithm: Choose one of the following algorithms for WPA-PSK and WPA2-PSK modes�
TKIP (Temporal Key Integrity Protocol): A security protocol used in IEEE 802�11 wireless networks�
TKIP is a “wrapperthat goes around the existing WEP encryption� TKIP is comprised of the same
encryption engine and RC4 algorithm dened for WEP; however, the key used for encryption in TKIP
is 128 bits long. This solves the rst problem of WEP: a short key length. (From Wikipedia)
AES (Advanced Encryption Standard): In cryptography, the Advanced Encryption Standard (AES), also
known as Rijndael, is a block cipher adopted as an encryption standard by the U�S� government�
As of 2006, AES is one of the most popular algorithms used in symmetric key cryptography(From
Wikipedia)
Pre-shared Key: Enter a key in ASCII format� The length of the key can be between 8 to 63 characters�
4�
WPA2-PSK: Use WPA2 pre-shared key
This advanced protocol, certied through Wi-Fi Alliance’s WPA2 program, implements the mandatory
elements of 802�11i� In particular, it introduces a new AES-based algorithm, CCMP, that is considered
fully secure. From March 13, 2006, WPA2 certication is mandatory for all new devices wishing to be
certied by the Wi-Fi Alliance as “Wi-Fi CERTIFIED.” (From Wikipedia)
NOTE
After wireless congurations are completed, click Save and the camera will reboot� Wait for the live
image ito be reloaded to your browserFor VIVOTEK 7000-series cameras, you have to unplug the
power and Ethernet cables from the camera; then re-plug the power cable to the camera� The camera
will switch to wireless mode�
► Some invalid settings may cause the system to fail to respond. Change the conguration settings only
if necessary and consult with your network supervisor or experienced users for correct settings� Once
the system has lost contact, please refer to Maintenance on page 83 for reset and restore procedures�

Table of Contents

Other manuals for Vivotek PZ7112

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Vivotek PZ7112 and is the answer not in the manual?

Vivotek PZ7112 Specifications

General IconGeneral
BrandVivotek
ModelPZ7112
CategorySecurity Camera
LanguageEnglish

Related product manuals