Vixel 9000 Series Installation & Configuration Guide CHAPTER 3 Managing the Switch
21
Stealth-3 Mode CLI Settings
Note: These commands are advanced settings and should not be modified unless
directed to do so by Vixel Customer Support.
To view the current Stealth-3 settings and available commands, type config mode
cfg from the Root Menu.
Using Other SNMP Tools
Vixel 9000 Series Switches can also be managed through CA® Unicenter TNG®
and other SNMP management tools.
Command Description
back Returns to the previous menu.
show Displays the current Stealth-3 settings.
alternate Enables the switch to allocate private
ALPA addresses in a specified range. For all
JBOD(s), the ranges must be between loop
address 1 - 94 (0x43 - 0xEF). Hosts are
restricted to Loop Address 95 - 125 (0x01 -
0x3C).
master Selects the specific switch to be the master
in a multiple Stealth-3 switch environment.
reset Forces all ports on the switch to shutdown,
re-configure, and restart.
deinsertion Enabling this option prevents LIP
notification from occurring when a
transceiver is physically removed.