MR 700
15
Ed. 3 - 2012_11
English
– During the design and construction
phases, the Manufacturer paid special
attention to the aspects which are liable
to cause any risk for the safety and health
of people interacting with the engine.
Besides complying with the relevant
legislation in force, he followed all the
“rules for a good construction technique”.
The purpose of this information is making
users aware of the need to pay the utmost
attention to prevent any risk. Caution is
however imperative. Safety also depends
on all the operators who interact with the
engine.
– Read carefully the instructions contai-
ned in the manual supplied and those
applied on the engine, in particular follow
those concerning safety. Spend some of
your time reading the instructions to avoid
unpleasant accidents.
– Pay attention to the meaning of the
symbols in the applied plates; their shape
and colour have a specic meaning rela-
ted to safety. Keep them visible and follow
the stated information.
– Use the engine only for the tasks autho-
rised by the manufacturer and do not tam-
per with any device to achieve a different
performance from the intended one.
– The staff carrying out any type of inter-
vention throughout the life of the engine
should have precise technical skills,
specic abilities and experiences acqui-
red and acknowledged in this sector. The
lack of these requirements may cause
damages to people’s safety and health.
– All the installation phases should
have been taken into account since the
development of the initial project. The
designer has to observe with the engine
xing points and the general indications
provided by the manufacturer.
– Carry out the handling of the engine in
compliance with the information stated
directly on the engine, on the packaging
and in the operating instructions supplied
by the manufacturer.
– When lifting or transporting unpacked
engines use means of appropriate load
capacity which must be properly ancho-
red.
– When lifting and transporting packaged
engines, means of appropriate load capa-
city as stated on the packaging itself.
– Before carrying out other transfers,
create the conditions required to guaran-
tee stability and to prevent any engine
part from being damaged.
– Before starting the installation, the
installer has to implement a “safety plan”
and to follow the designer’s indications.
Do not make changes to the engine com-
ponents for any reason.
– It is necessary to make sure that the
installation area is tted with all intake,
fuel supply and exhaust connections.
– The manufacturer cannot be held re-
sponsible for any damage resulting from
the misuse of the engine, from the failure
to follow the indications contained in this
manual and from any tampering with or
change made without the manufacturer’s
authorization.
– If appropriate, before using the engine
for the rst time, after gathering all the
necessary information, simulate a few
trial manoeuvres to identify the controls
and their main functions, especially those
related with starting and stop operations.
SAFETY INFORMATION
SAFETY RULES
To Next Page
Loading...
