VM Motori MR706LX - FUEL FILTER REPLACEMENT

MR 700
46
Ed. 3 - 2012_11
English
FUEL FILTER REPLACEMENT
Follow the procedure below.
1 -Turn off the engine and remove the
ignition key.
2 -Let the engine cool down adequately to
avoid being burnt.
3 -Prepare a container to collect any leak.
4 -Disassemble lter (Z) and replace it.
5 -Fill the new lter with the fuel from the
lter being replaced.
6 -Lubricate the gasket of the new lter
before mounting it.
7 -Replace the lter and screw the sump
back on.
8 -Bleed air from the fuel supply circuit
(see “Fuel supply circuit bleeding”).
9 -Turn the engine on and check for any
fuel leaks.
Warning - Caution
In the event of fuel leaks, identify and
eliminate the cause. If the problem
persists, contact one of the manufac-
turer’s authorised service centres..
Important
Do not throw away any polluting
material in the environment. Carry out
their disposal in compliance with the
relevant legislation in force..
RECOMMENDED LUBRICANTS
The lubricant recommended by VM MO-
TORI S.P.A. is: Q8 HD SPECIAL 10W-40
for operating temperatures from -20°C to
+50°C..
Oils of different brands can be used provi-
ded that they have the following features:
– Viscosity grade: SAE 10 W - 40
– Minimum specications:
ACEA A3/B4
API CF
Important
It is advisable not to mix oils with
different characteristics.
fuel lter (Z)
Tech Library http://engine.od.ua