MR 700
60
Ed. 3 - 2012_11
English
ELECTROLYTIC ZINC REPLACEMENT
Follow the procedure below.
1 -Turn off the engine and remove the
ignition key.
2 -Let the engine cool down adequately to
avoid being burnt.
3 -Unscrew the nut and replace the
electrolytic zinc (A).
ENGINE DISPOSAL
This operation should be carried out by
experienced operators, in compliance
with the legislation in force concerning
safety at the workplace.
Do not throw away non bio-degradable
products and non ferrous components
(rubber, PVC, resins, etc.).
While decommissioning the engine, divide
all the components depending on their
chemical composition and dispose of
them accordingly.
electrolytic zinc (A)
electrolytic zinc (A)
To Next Page
Loading...
