MR 700
28
Ed. 3 - 2012_11
English
ENGINE IGNITION AND TURNING OFF
Follow the procedure below.
Starting the engine
1 -Insert the key (T) and turn it clockwise
to position ON.
2 -Press button (N) to start the engine
and then release the button.
3 -Run the engine at a minimum speed
during the heating phase.
Important
Light-up of (red) indicator lights and/
or the sounding of a beeper indicate
the presence of a fault. In these condi-
tions, turn the engine off immediately,
then identify and eliminate the cause
of the fault.
Turn the engine off
4 -Run the engine at minimum idling
speed for 1-2 minutes.
5 -Turn the ignition key (T) anticlockwise
(pos. OFF) to turn off the engine.
All the warning lights go off.
6 -Remove the ignition key and store it
in a safe place known only to those in
charge.
In the case of turbocharged engines,
before switching the engine off it
should be run at minimum idle speed
for a few minutes in order to avoid
damaging the turbocharger.
If the indicator lights are still on
and/or the beeper still sounds when
the engine is turned on again, turn the
engine off immediately and contact
one of the manufacturer’s authorised
service centres.
To Next Page
Loading...
Need help?
General