R750EU5 - IE3 - TE4 - IE4 - ISE4
500 ORE
500 HOURS
English 39 Ed.8 / 10-2012
GB
Frequency (1) Component
Type of inter-
vention
Intervention
procedures
Reference
Every 900 hours
Drive belt (type
Poly-V) (5)
Replace
See “Changing
t belt (type
Poly-V)”
fuel tank
Clean the fuel
tank and check
the efciency of
the ller cap.
Air lter
Replace the
clogging indi-
cator
Every 1200
hours
Coolant (4) Replace
See “Coolant
replacement”
Every 4000
hours
Antiparticulate
lter
Perform the
regeneration
Apply to an
authorised
workshop
Every 4000
hours
Engine
Performing
partial overhaul
Apply to an
authorised
workshop
Every 8000
hours
Engine
Performing ge-
neral overhaul
Apply to an
authorised
workshop
(1) If an hour counter is not available, the frequency of
the interventions should be calculated on the basis of
a calendar day: one calendar day corresponds to 12
hours of operation.
(2) In hard working conditions, such as dusty environ-
ments and operation with extreme loads, change the
oil of the engine and the oil lter every 150 working
hours. If the engine has not worked for the specied
time, it will be necessary to replace the oil and the
lter all the same once a year.
The engine oil must in any case be changed, even
before the time limit indicated in the scheduled
maintenance programme, if the MIL
indicator indicator
light comes on with the ECU error 252F - “Engine oil
critical mass”..
(3) If the engine has not been in operation for the
length of time indicated, the lter must still be changed
at least once every 12 months.
(4) If the engine has not been in operation for the
length of time indicated, the uid must still be changed
at least once every 24 months.
(5) If the engine has not been in operation for the
length of time indicated, the belt must still be changed
at least once every 24 months
(6) In engine R756EU5 models with a high capacity
oil sump, a special plate is applied on the cover of the
engine valves to indicate that the engine oil and the oil
lter must be changed every 500 hours instead of every
300.
Periodic maintenance operation record sheet
For each maintenance operation, ll in the sheet,
so as to keep a trace of the operations performed
and therefore establish the most suitable methods
for future operations.
To Next Page
Loading...
