R750EU5 - IE3 - TE4 - IE4 - ISE4
English 46 Ed.8 / 10-2012
GB
MAINTENANCE IN CASE OF ENGINE INACTIVITY
After a period of inactivity, it is necessary
to carry out a few maintenance interven-
tions before starting the engine again to
ensure its maximum efciency conditions.
– Check the charge of the battery and the
liquid level.
–Make sure the electric contacts are intact
and properly working.
– Carry out the operation diagnosis of the
engine.
–Check the oil level, and, if necessary, top
up or replace it according to the esta-
blished intervals (See “Routine mainte-
nance (after running-in)”)
–Replace the oil lter according to the
established intervals (See “Routine main-
tenance (after running-in)”)
–Check the coolant level, and if neces-
sary, top up or replace it according to
the established intervals (See “Routine
maintenance (after running-in)”)
–Replace the fuel lter according to the
established intervals (See “Routine main-
tenance (after running-in)”)
– Replace the air lter according to the
established intervals (See “Routine main-
tenance (after running-in)”)
– Tension again the transmission belt
– Check the tightening of the hydraulic
unions (See “Control screw tightening and
union sealing”)
–Check the rubber gaskets and relevant
xing clips to ensure they are undama-
ged.
– Use a cloth soaked in a degreasing
product to remove the external protective
treatment.
–Start the engine and run it at minimum
speed for a few minutes (See “Engine
ignition and turning off”)
– If no anomalies are detected, bring
the engine to its operating temperature
(70÷80°C).
–Turn off the engine and check again the
engine oil and coolant level.
To Next Page
Loading...
Need help?
General