– To release, twist securing clips on angled connection pieces
-3- and -4-, and pull connection pieces off windscreen and rear
window washer pump - V59- -2-.
– Collect any escaping washer fluid in a suitable container.
– Pull windscreen and rear window washer pump - V59- -2- up‐
wards out of reservoir -5-.
– Release and pull off connector -1-.
Note
The connections to the pump and hose lines are colour-coded in
order to prevent the washer fluid lines being incorrectly connected
to the front and rear washer fluid pump - V59- . The hose con‐
nections must be connected to the correct colour-coded pump
connections during installation.
Installing
Install in the reverse order of removal.
2.4 Removing and installing washer jets
Removing
– Switch off ignition and all electrical consumers, and withdraw
ignition key.
– Push spray jet upwards -arrow A- and pull out of front flap
-arrow B-.
– Release securing clip -3- and pull hose connection -2- off
spray jet.
– Depending on the equipment, release and pull off connector
-1- and then remove spray jet.
Installing
up! 2017 ➤ , up! 2020 ➤
Electrical system - Edition 10.2019
60 Rep. gr.92 - Windscreen wash/wipe system
To Next Page
Loading...
Need help?
General
