86
Mode Start mode Stop mode Remarks
12
no display
indicator
Stop recording by
holding button ENTER
pressed for few
seconds.
13
no display
indicator
no display
indicator
“START DELAY MINUTES”
depending on
mode 1-13
13. LOGGING DATA
The data logger is dust tight and jet water protected with attached
protective cap (12) and rubber seals (9, 10) only. This protection
allows permanent logging operation in damp rooms and outdoors.
Before using ensure that the protective cap is tightly attached to
the data logger and the housing is completely closed.
Do not immerse into water!
Avoid operation near strong magnetic elds.
Do not cover the sensor openings.
• Ensure that rubber seals are in the correct positions and that the cap is
tightly put on the data logger.
• Place the data logger at the intended location.
To Next Page
Loading...
Need help?
General
