Why is the LC display off on my VOLTCRAFT Data Logger?
The LC display might be off on your VOLTCRAFT Data Logger because it was disabled during configuration. Alternatively, the battery may need to be replaced.
What to do if my computer does not recognize the VOLTCRAFT Data Logger?
If your computer isn't recognizing the VOLTCRAFT Data Logger, ensure that 'USB' is displayed on the data logger after you plug it in. If it is, try a different USB port. Also, verify that the USB mass storage device function is enabled on your computer.
What to do if there is no LED alarm on my VOLTCRAFT Data Loggers?
If there's no LED alarm on your VOLTCRAFT Data Logger, first check if the LED alarm is disabled in the configuration file. Also, verify that the alarm hasn't been paused.
Why no PDF file is generated by VOLTCRAFT DL-260A Data Loggers?
If no PDF file is being generated by your VOLTCRAFT Data Logger, verify that your computer recognizes the data logger. Also, check if your computer is showing the data logger as a new mass storage device. Finally, verify that the data logger is not upgrading the firmware.
How to fix unrealistic information on the LC display of VOLTCRAFT Data Loggers?
To correct unrealistic information displayed on the LC display of your VOLTCRAFT Data Logger, reset the data logger to the default firmware.
General| Type | Data Logger |
|---|---|
| Measurement Channels | 2 |
| Measurement Parameters | Temperature, Humidity |
| Humidity Range | 0 to 100 %RH |
| Accuracy Temperature | ±0.5 °C |
| Accuracy Humidity | ±3 %RH |
| Memory Capacity | 16, 000 readings |
| Logging rate | 10 s to 24 h |
| Interface | USB |
| Resolution | 0.1 °C / 0.1 %RH |
| Battery Life | up to 1 year |
| Temperature Range | -20°C to +60°C |
To Next Page
