VOLTCRAFT DL-260A - 14 Create PDF Report; 15 Delete Data

51
14. Create PDF Report
• Connect the data logger to your computer.
• A PDF report is produced automatically. Red LED control light (2)isonand“USBPDF”isshownintheLCdisplay.
Do not disconnect the data logger from your computer during this period.
• Open the data logger drive on your computer.
• OncethePDFlehasbeengeneratedsuccessfully,“PDF”disappearsfromtheLCdisplay(4).“USB”remainson
the LC display.
• SelectandopenthePDFle.
• The PDF report contains general device information, data logger settings, alarm statuses and a graph showing the
measured values during the recorded time.
• SavethePDFleonyourcomputerandclosethele.
• Disconnect the data logger from your computer.
 Dependingonthenumberofstoredmeasurements,generatingthePDFlemaytakeuptoapproximately
30 seconds.
Only the maximum and minimum measurements during recording will be shown in the PDF report but not
during the pause function.
15. Delete data
Generate and save the PDF report before deleting measured data, if needed.
 Deletingdatadoesnotaffectthecongurationsettings.
• Press and hold buttons DOWN (5) and ENTER (7) andconnectthedataloggertoyourcomputer.“USB”isshown
in the LC display. All data is deleted.
• Release the buttons.
• The data logger driver on your computer is empty, that means all data was successfully deleted. Disconnect data
logger from your computer.