VOLTCRAFT DL-260A - E) Create Configuration File By Website; F) Load Configuration File Created On The Website Onto The Data Logger; G) Review Configuration Settings

44
e) Create conguration le by website
• Afterperformingcongurationsettings,select“CREATECONFIGURATION”todownloadthecongurationleto
your computer.
• Anewwindowappearstochangethecongurationlename.Defaultnameis“Setlog”.Ifneeded,changethe
nameofthele.
• Conrm the lenamebyclicking“CREATECONFIGURATION”.Yourcongurationlehasbeendownloaded/
imported to your computer.
f) Load conguration le created on the website onto the data logger
• Remove protective cap from the data logger.
• Connect the data logger to your computer.
• Draganddropthecongurationlefromthedownloadfolderofyourcomputertothedataloggerfoldertoexecute
theconguration.
• The green LED control light (3)ashestwice,whenthecongurationleissuccessfullyinstalledonthedatalogger.
• Whenthedataloggeriscongured,disconnectthedataloggerfromyourcomputer.
g) Review conguration settings
• Startmodeisbasedonthecongurationsetting“RECORDSTARTCONDITION”.
• Stopmodeisbasedontheconguration“STOPSTYLE”.
• Youcancheckwhichstartmodeisactive,byloadingtheexistingcongurationleintothewebinterface,inthePDF
report or by entering the function menu of the data logger.
• Youcancheckwhichstopmodeisactive,byloadingtheexistingcongurationleintothewebinterfaceorby
entering the function menu of the data logger.
• Forfurtherinstructionsregardingloadingtheexistingcongurationsettings,pleasereferto"Othersettings"on
page 43.
• For further instructions regarding entering the function menu, please refer to "a) Enter function menu" on page 49.