VOLTCRAFT DL-260A - 10 Before First Use; A) Protection Foil; B) Insert;Replace Battery

38
10. Before rst use
a) Protection foil
• Remove the protection foil from the LC display (4).
b) Insert/replace battery
• Installthebatterybeforerst-timeuseorreplacethebatterywhenthebatterysymbol“ “appearsintheLC
display.
Removing and replacing batteries does not delete data or settings.
• Remove the protective cap from the data logger.
• Press and hold the button release battery compartment (6) and pull out the logger unit from the housing. The hous-
ingtstightlyduetothesecondrubberseal(8).
• Release the button release battery compartment.
• Thebatterycompartmentisonthebackoftheloggerunit.Insertanewandsuitablebattery(see"21.Technical
data"onpage55)intothebatterycompartmentobservingcorrectpolarity(positive/+andnegative/-).
• Slide the logger unit back into the housing. Ensure that the LC display matches to the LCD window of the housing.
• Place the protective cap back onto the data logger.
The data logger performs best at room temperature. If the item is used at extremely low temperatures,
the battery life is reduced. In such case, you can reduce power consumption of the data logger in order to
prolong the operation time as following
- disable LC Display
- disable LED alarm
- set a longer sampling rate
 Fordetailsrefertochapter"11.Conguration"onpage39
.
1 2
3 4