49
13. Logging data
The data logger is dust tight and jet water protected with attached protective cap (10) and rubber seals (8)
only. This protection allows permanent logging operation in damp rooms and outdoors.
Before using ensure that the protective cap is tightly attached to the data logger and the housing is com-
pletely closed.
Do not immerse into water!
Avoidoperationnearstrongmagneticelds.
Do not cover the sensor openings.
• Ensure that rubber seals are in the correct positions and that the cap is tightly put on the data logger.
• Place the data logger at the intended location.
• The protective cap must be removed for inserting/changing battery or reading the saved data via a computer. Pull
the protective cap off the device.
• Attach the protective cap tightly to data logger before next recording.
a) Enter function menu
Press button DOWN (5) to enter the function menu. The latest recorded measurement, logger ID and selected start/
stopmodeduringcongurationappearinsequencebyconsecutivepressesofthebuttonDOWN (5).
b) Start recording
• Recordingstartsbasedoncongurationsetting“RECORDSTARTCONDITION”.
• Whenthedataloggerstartsrecording,“
”appearsontheLCdisplay.
• “P”indicatesdataloggerisreadyforrecordinganditdisappearsoncethedataloggerrecords.
c) Stop recording
• Recordingstopsbasedonthecongurationsetting“STOPSTYLE”.Whenthe“NONE”stopstylewasselected,
thentherecordingstopsbasedonthesetting“RECORDSTARTCONDITION”.
• Whenthedataloggerstopsrecording,“
”appearsontheLCdisplay.
d) Show remaining time until start/end of recording
• Press button DOWN (5) to enter the function menu.
• Press button DOWN (5)consecutiveuntil“TIMESTART”and/or“TIMESTOP”andremainingtime(inhours/min-
utes or days) are shown in LC-display.
• Timedurationbelow24hoursisinHH:MMformat.Iftheremainingtimeexceeds24hours,itisshownasdays“
”.
• Once the recording starts/stops, the latest measurement is shown in the display.
• Press button DOWN (5) to return to function menu.
To Next Page
Loading...
Need help?
General
