37
9. Initial operation
a) Protective cap
The data logger is only dust tight and jet water protected with attached protective cap (10) and rubber seals
(8). This protection allows permanent logging operation in damp rooms and outdoors.
• Only remove the protective cap for replacing the battery or reading the data on the computer.
• Removetheprotectivecapbypullingitofffromthedatalogger.Theprotectivecaptstightlyduetotherubber
seal (8).
• Place the protective cap tightly back onto the data logger.
b) Connect to the computer
• Remove the protective cap (10) from the data logger.
• Connect the data logger to an available USB port of your computer.
• The computer recognizes the new hardware. The model type of your data logger appears as a mass storage device
on your computer.
c) Disconnect from the computer
• Eject the data logger from your computer and remove it.
• Place the protective cap back on the data logger.
d) Choose start/stop mode
• Choosestartmodefrom“RECORDSTARTCONDITION”duringconguration.
• Choosestopmodefrom“STOPSTYLE”duringconguration.
e) Dene date and time during conguration
• Selectmonth,yearandtimewithdatepickerandtimesliders.Thetimewillbeshownas“TIME”inHH:MM:SS
format.Conrmwith“DONE”.Dateandtimesettingsaredisplayedinthecorrespondingelds.
• Alternatively,click“NOW”,ifyourequireanimmediatestartoflogging.Actualdateandtime-asperlocallyseton
yourcomputer-willbelledautomaticallyintoeld“STARTTIME”/“STOPTIME”.
f) Button ENTER
• Press button ENTER (7) to switch between maximum and minimum reading.
• Press and hold button ENTER (7) for few seconds to start/stop logging or activate/deactivate pause function.
To Next Page
Loading...
Need help?
General
