Loop.
(2) Press the ▼ key to select Start Point submenu. Use the numeric keys to input (1 to
100), press the key to confirm.
(3) Press the ▼ key to select Stop Point submenu. Use the numeric keys to input (1 to
100), press the key to confirm.
(4) Press the ▼ key to select Start submenu. Press the ＜ / ＞ key to select the
channel (CH1, CH2 or ALL), press the key to enter the data processing interface
and output the selected channel.
4.4.3 Data process
You can set the programmable parameters of CH1 and CH2, including voltage, current
and output time. This function allows up to 100 parameter groups of each channel.
Press the Program key, turn the knob to select [Data process].
Edit:
(1) The Edit sub menu is selected. The operation instruction shows on the screen. Press
the key to enter the data processing interface.
(2) In the data processing interface, Press the ＜ / ＞ key to move the cursor left and
right. Press the ▲ / ▼ key to move the cursor up and down. Turn the knob to move
the cursor between CH1 and CH2. Use the After selecting the parameter, use the
numeric keys to enter a desired value, press the key to confirm.
Figure 4-1 Data processing Interface
(3) Press ← to back to sub menu selection.
Graph process is used to configure the graphical display in the Data processing
interface.
(1) Press the ▼ key to select Graph process submenu. Press the key to enter the
editing interface.
To Next Page
Loading...
