(2) In the Graph processing interface, Press the ＜ / ＞ key to move the cursor left
and right. Press the ▲ / ▼ key to move the cursor up and down. Press the key
to check or uncheck the item. If the item is checked, the corresponding line will be
displayed in the chart in the data processing interface.
(3) Press ← to back to sub menu selection.
4.4.4 Turn On/Off Programmable Output
In the data processing interface:
Independent Mode
Press yellow ON/OFF key to turn on/off the programmable output of Channel 1.
Press blue ON/OFF key to turn on/off the programmable output of Channel 2.
Parallel/Series Mode
Press yellow ON/OFF key to turn on/off the programmable output.
In the data processing interface:
Press the ▼ key to select Start submenu. Press the ＜ / ＞ key to select the channel
(CH1, CH2 or ALL), press the key to enter the data processing interface and output
the selected channel.
Note:
In the process of programmable output, closing the channel output will reset the timer;
turning on the channel again will restart the programmable output and the timer.
4.5 Save Settings/Auto Record
4.5.1 Save Settings
You can store, recall and delete current setting parameters. The storage memory could be
set as internal or external (USB flash device). Up to 100 groups of settings can be saved.
Press the Record key. The Save Settings menu is selected.
(1) The Memory sub menu is selected. Press the ＜ / ＞ key to select Internal or
External.
(2) Press the ▼ key to select Save submenu. Press the ＜ / ＞ key to select the
channel (CH1, CH2 or CH3), press the key to save the setting of the selected
channel.
Note: When the memory is set as External, the setting will be saved to U disk as a
CSV file, the directory is DLPXXXX\Record_Option (DLPXXXX is the model).
To Next Page
Loading...
