VOLTCRAFT VC-335 - 2 Intended Use

29
2. INTENDED USE
A clamp multimeter for measuring and displaying electrical parameters in measuring category
CAT II up to max. 600 V and CAT III up to max. 300 V against ground potential; in compliance
with EN 61010-1 and all lower categories.
• DC and AC voltage measurements up to max. 600 V
• Direct and alternating current measurements up to max. 200 A
• Resistancemeasurementsupto20MΩ
• Continuitycheck(≤10Ωacoustic)
• Diode test
• Capacitance measurements up to 20 mF
• Non-contactACvoltagedetection(NCV)≥100-600V/ACand≤8mmdistance
The voltage in the circuit to be measured may not exceed 600 V in CAT II or 300 V in CAT III.
Themultimetermaybeoperatedwiththespeciedbatterytypeonly.
Do not operate the multimeter with the housing or battery compartment open or if the battery
compartment cover is missing. Measurements in wet rooms or in adverse ambient conditions
arenotpermissible.Adverseambientconditionsaredenedassuch:Wetconditionsorhigh
humidity,dustand ammablegases, vaporsorsolventsaswellasthunderstormsorsimilar
conditionssuchasstrongelectrostaticelds,etc.
Onlyusetestleadsandmeasuringaccessoriesthatmeetthemultimeter'sspecications.
For safety and approval purposes (CE), you must not rebuild and/or modify this product. If you
use the product for purposes other than those described above, the product may be damaged.
Inaddition,improperusecancausehazardssuchasshort-circuiting,re,electricshocketc.
Read the instructions carefully and keep them for future reference. Make this product available
to third parties only together with its operating instructions.
The product corresponds to the legal, national and European requirements.