56
Proceed as follows to insert or change the batteries:
• Disconnect the connected measuring leads from the measuring circuit and
from the multimeter. Disconnect the multimeter from all measured objects.
Power the multimeter off.
• Loosen the rear screw on the battery compartment cover (13) with a suitable
Phillips screwdriver. The screw cannot be completely removed. Remove the
battery compartment cover.
• Replace all used batteries with new ones of the same type. Insert the new
batteries into the battery compartment in the correct polarity. Refer to the
polarity markings in the battery compartment.
• Carefully replace the battery compartment cover.
Never use the measuring instrument when the battery/fuse com-
partment is open. FATAL HAZARD!
Do not leave empty batteries in the device. Even leakproof batter-
ies may corrode and destroy the device or release chemicals that
are detrimental to your health.
Do not leave batteries unattended. They may be swallowed by
children or pets. Seek immediate medical attention if a battery
is swallowed.
If you do not plan to use the multimeter for an extended period,
remove the battery to prevent it from leaking.
Leaking or damaged batteries may cause acid burns if they come into contact with your skin. Always
use protective gloves when handling leaking or damaged batteries.
Ensure that the batteries are not short-circuited. Do not throw batteries into re!
Do not recharge or disassemble non-rechargeable batteries. This may cause a re or explosion.
Use the following item number to order compatible Alkaline batteries:
item no. 652303 (2 pieces, please order 1 pack).
Only use alkaline batteries, as alkaline batteries are more powerful and have a longer lifespan.
To Next Page
Loading...
Need help?
General
