- Measuring and displaying electrical parameters in the range of the measuring category CAT
III up to max. 500 V against earth potential according to EN61010 and all lower categories.
- Direct and alternating voltage measurement up to max. 500 V
- Measuring direct currents of up to 10 A
- Measuring alternating currents of up to 500 mA
- Measuring resistances up to 10 MΩ
- Acoustic continuity test
- Battery Test
Only use with the stated type of battery.
The meter must not be operated when it is open, i.e. with an open battery compartment or
when the battery compartment cover is missing. Measurements in moist rooms or under detri-
ment ambience conditions such as wetness or high humidity, dust, ammable gases, vapours,
solvents, thunderstorm or strong electrostatic elds are not permissible.
For safety reasons, only use measuring lines or accessories which are adjusted to the speci-
cations of the meter when measuring.
Any use other than that described above damages the product. Moreover, this is linked to
dangers such as short circuit, re, electric shock, etc. No part of the product must be modied
or converted!
Read the operating instructions carefully and keep them for later reference.
Always observe the safety information!
To Next Page
Loading...
Need help?
General
